Delica Canada | Mitsubishi Van Club

sorry, i didnt take any photos. but i will make it a bit more clear what i actually did. i removed the retaining clip from the helical gear to remove it, I then fliped it over so the worn end was at the bottom and the unused end was at the top. i think that part is pretty simple and im sure everyone...

the gear on my sun-roof motor was worn to the point that it was slipping constantly. to fix it i flipped the gear, and then swaped the location of the two switches ( activated by the red paltic cam under the gear) that control how long the motor runs to pop up the end, and than fully open the roof. ...

hey all as a x-mass present to myself i decided to get a new cd player. has anyone replaced thier old tape decks? ive done some searching and havent been able to find any info on wiring adapter that would work. the only info i found was that the harness for a dodge colt would fit but i imagine that ...

it turned out that some of the seals in the valve cover were worn out and oil was coming into contact with the spark plug wire causing a short, and occaisionaly to push the boot of the plug. I took it to a shop and had them replaced. since then the light only comes on at start up. im in kelowna so i...

doubtfull, it is definatley related to the poor engine performance. when give it gas the engine slowly gains rpm's around 3000 rpm the light will come on and stay on.

I was thinking possibly a fuel filter lamp? does such a thing exist?

hey all, i have a 1994 l400 with the 4g64 engine. the bottom left hand side warning light keeps coming on and the engine sputters at low rpm, once the rev's get over 2000 its gets better. the manual i have lists the bottom left location as #6 and is unknown. anyone know what that one means? it looks...

im not having any luck uploading any pictures, but the pic posted above is almost identical to what ive got. could someone post some pictures of how where and what they trimed to minimize rubbing

I really appriciate this post, i have recently bought an L400 and it does sit higher than others i have seen. it has 31inch tires and for the most part they dont rub. but when the wheels are turned max there is only a one inch gap left between the inner fender and tread. is this the same as all the ...