Rubber Gasket on Cabin Air Intake not sealing right?

Mitsubishi Delica L400 production commenced in 1994 -- After much anticipation, the L400 arrived on Canadian Soil in 2009!
Post Reply
User avatar
CREGAN
Posts: 1094
Joined: Thu Sep 24, 2009 8:05 am
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 94 L400 SpaceGear Super Exceed
Location: Leduc, Alberta

Rubber Gasket on Cabin Air Intake not sealing right?

Post by CREGAN »

Does anyone know if you can get a new replacement of the round rubber gasket that gets compressed on the air intake system when you close the hood (not sure if that makes sense but it is the rubber you see right above the battery on the intake)? I am still having trouble with the strong smell coming into the cabin from the engine bay. Many different opinions from some observers (smells like spent diesel, just a regular diesel engine smell, etc.) I have ruled out exhaust as I took it to a muffler shop and they traced from the manifold back to the tail pipe and there was no leak. FishTank is here and he noted it smells like a hot diesel engine running. It is driving me nuts because it blows right into your face! It is only a noticible smell when you are stopped while running. At highway speeds it is not there.

I have noticed this rubber gasket does not seem to be compressed at the top, and very compressed everywhere else. Just wondering if the gasket is not sealing properly and I am getting the smells coming off the engine. This only started in late January. I have been putting a used dryer sheet doused in air freshner over the duct opening and that numbs it somewhat but only for a little while. Not sure what can be done, but any suggestions are welcome.

Craig
User avatar
Mr. Flibble
Posts: 1396
Joined: Tue Nov 03, 2009 7:31 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1995 L400 Royal Exceed
Location: Issaquah, Washington
Location: Issaquah, Washington

Re: Rubber Gasket on Cabin Air Intake not sealing right?

Post by Mr. Flibble »

Look for a used seal from a wreckers/dealer, should be easy to find in the Vancouver area.
Canadian living in Washington USA
Post Reply

Return to “L400 Technical”