FS: 2" Springs/shocks

[.:FoRuM56:.]

Not sure if I can post this in here, since it's not delica related but a listing.

Up for sale, I have a set of rear 2" lift springs, (Unknown Brand, From Japan?)
Came out of a 1991 LWB Pajero.
Just pulled them to replace with a set of Y60 coils
I'd say they are atleast 6 years old, since that's how long the truck has been in Canada.

And a nearly new (Less than 200kms) Set of pro-comp ES3000 shocks. Works with the 2" lift.
I purchased these out of desperation to get my truck on the road till I could find a different set of shocks for my rear springs, and a desired stiffness.
Part #318510/314515

Disclaimer!!
Comes with hardware, Minus the rear lower bushings. It has the bushings but I swapped them from a different set of shocks so they are larger. I was told I could go to a pro comp dealer and grab new bushings and sleeves. I assume it would be cheap but I didn't bother with it.

Also adding the shocks are a soft ride.

I paid a little over $200 for the shocks, I just don't have any use for them and the springs.
See if anyone wants the lot for $150.00 obo (possibly consider trades)





This is how the truck sat with those springs, T-bars wound up and a 2" body lift. Picture was taken in July this year.


IMG_2312 by .:FoRuM56:., on Flickr

Thanks
James

[Torqueluvr]

I'm interested in the lot. Would the rear shocks fit stock springs until I find the time and money to get the front lifted and install those rear springs?

[.:FoRuM56:.]

They would, they're dealer rated at 0-1" but still clear for 2". Also, you can lift the front end for free! Just wind up the T-bars lol.