I'm hoping to avoid breaking anything and was wondering if there is anything to know when removing the lamp at the roof very rear of the van.
Sorry I couldn't find this thru search, perhaps because I don't know the exact term for this light.
Rear Hatch Overhead Lamp
-
sealica
- Posts: 148
- Joined: Mon Aug 08, 2016 5:38 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 L300 P35W, White
- Location: Vancouver Isle
-
Growlerbearnz
- Posts: 2041
- Joined: Sat Jun 26, 2010 1:58 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica P25W
- Location: New Zealand
Rear Hatch Overhead Lamp
Not really. The lens pops off first, there's a little groove on each end to get a screwdriver into, then it's two screws and a 2-pin plug.
Finding the groove on the lens might be a bit tricky the first time, as both the lens and the sliding part it's clipped to are transparent.
Finding the groove on the lens might be a bit tricky the first time, as both the lens and the sliding part it's clipped to are transparent.
Nothing says "poor workmanship" more than wrinkles in the duct tape.