Using Idle Control Knob on Startup - Proper Engine Care?
-
Adrock
- Posts: 750
- Joined: Fri Jan 12, 2007 11:02 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Location: Richmond B.C.
Re: Using Idle Control Knob on Startup - Proper Engine Care?
i need to go back t o kimberley... -28 was fun.
"if its so hard to pull on your knob, put some greese/wd40 on the shaft and pull in and out, that should make it happen for you."
-westcoastnewbie
-westcoastnewbie
-
Schwa
- Posts: 480
- Joined: Tue May 01, 2007 5:16 pm
- Vehicle: 1992 Delica Exceed
- Location: Coquitlam
- Contact:
Re: Using Idle Control Knob on Startup - Proper Engine Care?
mine's been missing and smoking lately on startup when it's cold out, so unfortunately it does need warming up, but I have a feeling my timing is to blame more than the cold, although I'm sure it'll get worse as it gets colder
-
coaxial
Re: Using Idle Control Knob on Startup - Proper Engine Care?
Yeah with not even dipping below 0 here I'm not too worried, I just give it enough time to get some warm air on the windows so I can see and I'm off... I go easy on the gas pedal until the temp gauge registers some warmth 