Re: L300 cup holder
Posted: Sun Jan 22, 2012 4:36 pm
No problem, glad to help.
The only thing I had to do to get it installed was hack saw off the wire management tab at the bottom of the cup holder. Just slid right in after that, no screws required. Depending on the size of your existing stereo you may need to trim the cover on the dash a little bit to. It'll make sense when you see it. Good luck!
The only thing I had to do to get it installed was hack saw off the wire management tab at the bottom of the cup holder. Just slid right in after that, no screws required. Depending on the size of your existing stereo you may need to trim the cover on the dash a little bit to. It'll make sense when you see it. Good luck!