Page 2 of 2
Re: Rim Compatibility
Posted: Thu Jul 16, 2015 7:28 pm
by P.Gaudreault
There is a shop here who he charge 75$$ pers wheel for machining a guy told me. 300$$ for 4. Aaaouchhh!!
Thank you
Re: Rim Compatibility
Posted: Fri Jul 24, 2015 8:19 am
by P.Gaudreault
33 mm is the offset of our van and 6'' width. I found this info on the web. Do you have the same??
http://www.wheel-size.com/size/mitsubishi/delica/
If I buy rims with 0mm offset and 8'' width, it will looks good.
Re: Rim Compatibility
Posted: Tue Dec 15, 2015 12:57 pm
by Croftcastles
Did you end up getting these offset rims?
Any idea if you kept the 33mm offset and went 8" wide, would your tires rub with the wheel cranked?
Re: Rim Compatibility
Posted: Thu Dec 17, 2015 5:45 am
by Big-Bird
Alberta Wheel Repair in Calgary charged me $40 per loose rim to CNC the center hole on my Toyota Steel rims. 15x8 with a .5" wider offset than stock so they give a wide stance.
Stuffed a set of 31x10.50x15 arctic claws on them...great winter combo.
Re: Rim Compatibility
Posted: Thu Dec 17, 2015 9:00 am
by thelazygreenfox
Croftcastles
The answer is yes! One time I had a BFG AT KO and compared it to a Michelin of the same size 15x 9.50. The only difference was in the (1/2") width of the tire tread.
When cranked the BFGs hit and the Michelins didn't. Go figure but needless to say I bought the Michelins.
TLGF
Re: Rim Compatibility
Posted: Thu Dec 17, 2015 3:28 pm
by Croftcastles
Thanks Gents!
TLGF - I'm assuming you're running wider than stock rims? Also assuming the size of these Michelin's would be 30"?