Delica Canada | Mitsubishi Van Club

Sorry, just realized you are simply blocking flow while leaving the EGR in place, thus 1/16" is plenty. I prefer to remove it all together if only to "clean" up the engine bay, although in my opinion it is the best place for a pyro as well.

I will take one too

Jason

I'll take one too...

Thanks for taking the initiative... been thinking about this since I had the Van... but never moved on it...

Thanks Falco...

Cheers,
Chris

Did you count me in? I want one too!

for $15 I'll just buy it. If I pulled the gasket then I'd have to do it at work (otherwise I'd have no way to get there!), fab the plate, re-install it and hope I didn't screw anything up.

for sure want one

I'm in

Mephisto wrote:I would suggest a 1/4 inch thickness as a minimum, as there is a lot of heat and pressure held by two bolts 1/16" is nowhere near enough.

Kit I bought is 6mm (1/4")

At that price, why don't you just group buy the kit at discount?

http://cgi.ebay.co.uk/EGR-Removal-Blank ... 4222871882

I'm definitely in...

Thanks,
Chris

RichD wrote:Kit I bought is 6mm (1/4")

This would be for the complete truncation of the EGR valve, no?

The idea behind this plate is for the convenience of just slipping the gasket out and slipping the plate in so you can use the same bolts.

I looked at that ad, Rich, they currently have it at a special price:
"GRAB YOUR CHANCE TO BUY AT THIS NEW VASTLY REDUCED RECESSION BEATING PRICE OF £19.00, PREVIOUSLY SOLD AT £23.50"

I am talking about 15 Canadian dollars, not UK pounds. I already have a plate in the Miss Lil' Bitchi ~ but I have a friend who can make them ~ this is the way I see it: The club benefits + my friend benefits = everybody benefits ~ it's a mutually beneficial equation (and it makes me look pretty good, too).

This is what it looks like:


Falco.

From the look of things, the blanking kit on ebay also blanks the L400 and the Pajero - not just the L300, so I bet there are some L400 owners - such as myself - who would be interested. (Provided that it can support my EGT thermocouple).

Can I get one too????

this is the plate needed to install a pyro sensor isn't it?

if so, then you can count me in please. not sure when ill be in the lower mainland next. maybe in august.