Delica Canada | Mitsubishi Van Club

I put in 4 white for the 194 socket 'cause that's what I had on hand, one of them has already lost contact and gone out already due to the problem noted above. the blue and red? (I put red in the driver's side overhead map light and it seems good).

Who did you order your LED lights from?

I got them from SUperbright LED's but I wasn't really too happy with them, they really ripped me on shipping charges.

I'd recommend Nick Chiang [nick.chiang@wafflepod.com] in Australia. Dealt with him the first time and he can supply most of the bulbs and shipping is faster than the USA and cheaper, bulbs are a bit more.

http://stores.ebay.com.au/BioLiving-Bea ... tZkm#items

JMK wrote:Ooops sorry, should be T10, 194 socket I believe.

Any change to get the right size and the right amount of LED's you need to replace them all? It's a little bit confusing how many and what size you used in the end.

Thanks

I understand there is a bit of variance between different models if Delica. Best bet is to compare the list above with your vehicle and see if it looks the same. You could always order an extra bulb or two to be safe. While you're at it check the heater control panel beside the rear passenger seat, mine was burnt out and needed a new bulb there as well.

There are six bulbs in the instrument cluster.

I'm interested to know, are the bulbs in the ventilation control panels the 194-bulbs as well? If so, how many in each? I haven't pulled mine apart yet, but I'm going to, and all the switches too. Will post more about that later, in another thread.

I'm thinking I remember I had to go chase down a T10 194 but I might be wrong, so you better double check. I recall you can pop it right up without removing the panel.

I've posted this before but keep getting asked, so here's the link again to who I prefered to source my lights from:

http://cgi.ebay.com.au/ws/eBayISAPI.dll ... EL:AU:1123