Delica Canada | Mitsubishi Van Club

Are these the ones your looking for?

Hmmmm,... those might just be them! I’ll go climb under and have a good look around tomorrow...

These are for the Automatic transmission. I found the correct ones on Amayama.com. The manual transmission exploded view is below the A/T view , which I had not noticed.

Just wondering, has anyone cast their own bushings?

Ebay sells a lot of delica bushings. The ones supplied by Febest (Chinese but w a plant in Florida) have worked out well for me. I've replaced all but 2 bushings on my L400. I've done all but the rear trailing arm on one side just cuz of lack of time. It's a big job replacing some of the front drive bushes.

The conclusion after 3 years is Febest bushings are cheap and good but their brake rubbers are terrible.

Febest won't sell directly but their website shows which delica buses they carry and quantity in stock.
Take care
MD

In addition Febest ships in a week to the USA post office box.
MD

you open it in "PREVIEW"
then go to TOOLS
then go to ADJUST SIZE
then change the WIDTH & HEIGHT from 100% to 30%
then SAVE

should work..

you can just redo it again and again and change the % until its small enough to upload on here.