Page 1 of 1
Info on running wiring for Boost/Pyro on 94 L400...
Posted: Fri Apr 08, 2011 8:59 am
by Aciled
Well I've managed to gather all my parts to install a RHD 2-gauge pillar pod. I'm wanting info on running the wires and tube (Boost) down the window pillar.
Anyone of there know of some pics or have instructions ?
Thanks in advance,
EN
Re: Info on running wiring for Boost/Pyro on 94 L400...
Posted: Fri Apr 08, 2011 11:12 am
by psilosin
Pics of the pillar pod!
Did you source it local or have it shipped over from Australia or similar?
Re: Info on running wiring for Boost/Pyro on 94 L400...
Posted: Fri Apr 08, 2011 3:56 pm
by Aciled
psilosin wrote:Pics of the pillar pod!
Did you source it local or have it shipped over from Australia or similar?
Happened upon it on CL.... Looked under JDM parts.
Re: Info on running wiring for Boost/Pyro on 94 L400...
Posted: Sat Dec 15, 2012 1:21 pm
by Mr. Flibble
Do you have more pics of this setup? Glowshift sells RHD 2 and 3 pillar gauge pods, and I am wondering if there is room for the 3 gauge pod...
Re: Info on running wiring for Boost/Pyro on 94 L400...
Posted: Sat Dec 15, 2012 4:42 pm
by RickJ
Hi I just ordered a similar pillar off ebay. In the meantime I have installed and wired my boost and pyro. As for power for the pyro, I found an unused plug behind the glovebox which has one terminal switched for 12V. Using a spade crimp connection I have robbed the source from there. The ground is attached to a chassis bolt in the same neighborhood. I teed into the light dimmer for the lighting power but it works in reverse to the dash lights so for now I just used the same power source as the pyro power. This means lighting at all times but for now this is something I can live with. A note, I bulb and green condom supplied sucks...I purchased 2 autometer brand LED replacement bulbs for 12 a piece at lordco and they are quite an improvement.
Rick
