Page 1 of 1
What does this clip do?
Posted: Fri Sep 16, 2011 3:39 pm
by CREGAN
Can anyone name this clip? I found it when I was fiddling with my TPS and it is so loose it just slides off. If I hit a bump it would probably fall off. Not sure what it goes to or is for. Just wondering if I can cut it off and get a slide on connector from CT to replace this one. Thanks
Craig
Re: What does this clip do?
Posted: Fri Sep 16, 2011 3:53 pm
by Rising Sun Auto Import
That's the oil pressure switch connection.
Most of the time old one is too loose to hold.
Steven
Re: What does this clip do?
Posted: Fri Sep 16, 2011 4:06 pm
by CREGAN
So Steven can I just replace it with any old slide on clip? I was going to cut the end off and crimp it into a new slide on clip.
Craig
Re: What does this clip do?
Posted: Fri Sep 16, 2011 4:21 pm
by psilosin
I did exactly that Craig. Just crimped on a new female spade connector...10 seconds and good as new.
Re: What does this clip do?
Posted: Fri Sep 16, 2011 4:23 pm
by Rising Sun Auto Import
psilosin wrote:I did exactly that Craig. Just crimped on a new female spade connector...10 seconds and good as new.
X2.
Re: What does this clip do?
Posted: Fri Sep 16, 2011 4:36 pm
by CREGAN
Right on - Thanks guys. Finally something I know I can do!
Craig
Re: What does this clip do?
Posted: Fri Sep 16, 2011 9:07 pm
by CREGAN
psilosin wrote:I did exactly that Craig. Just crimped on a new female spade connector...10 seconds and good as new.
I did it and it worked out no problem. Thanks