Delica Canada | Mitsubishi Van Club

Hey everyone,

My electronic ride height control has been acting up lately. When I enable it, it works fine (pressures up at a normal rate). However, when I am just driving with it disabled, sometimes the "HIGH" light on the dash (which informs me that the vehicle is lifted) flashes a few times. AFAIK, the system, when disabled, should never activate.

Does anybody know what could be causing this flashing? I don't feel any change or notice it lifting, but I'm thinking something is malfunctioning.

TIA,

Chris

Consider yourself uber fortunate that the ride height shocks were working to begin with.

If the solenoids on the shocks are not clicking when you change the selector but the dash light pops on, sounds like a loose connection between the switch and the instrument cluster.

The suspension lift works perfectly fine - operating the switch has the proper response. I just notice that when I'm not using the lift, the light flashes occasionally when im just driving normally.

flickering indicates a intermittent/loose electrical connection. I would start at the switch and if you have the time, behind the console.