Broke my weird exhaust hanger.
Posted: Mon May 28, 2012 8:56 pm
I recently noticed that my tailpipes were the cause of the vibration sound at the rear of the van; one was too close to the bumper, the other was just loose (dual pipes).
I intended on doing a quick tighten of the nut which holds the rubber grommet. I was a little heavy on the wrench and broke the bolt/grommet section in half.
Can I ask if anyone has experience in replacing these grommets? How do I remove the remaining broken bit? and where is a good place to get a replacement?
Thanks ever so much,
Jamie.
Photo is of the non-broken side...
I intended on doing a quick tighten of the nut which holds the rubber grommet. I was a little heavy on the wrench and broke the bolt/grommet section in half.
Can I ask if anyone has experience in replacing these grommets? How do I remove the remaining broken bit? and where is a good place to get a replacement?
Thanks ever so much,
Jamie.
Photo is of the non-broken side...