Fresh of the boat, TO DO list on your Delica...(maintenance)
Posted: Sun Nov 11, 2007 2:27 am
This topic may already have been covered (partially?) but I'd like to end up with a comprehensive (but realistic) list of what all of us should do or think of doing to our "new" Delica once it comes off the boat to make them "keepers". (aside from paperwork...) I've added part number if available (more part # should be available on Wiki?). Your input would be great even if it's to correct me or add what's missing! This is what I came up with:
EGR; clean or block
Turbo Pressure; check
Tires; DOT, 235x75x15 (or 30"x9.5x15)
(If I wish to get tall and narrow tires, what would you suggest?)
Tranny oil: Take out pan, put new gasket & strainer metal filter ($25-30, '90 Montero kit),
use Destron 3 oil from Toyota (every 20-25K) How much is needed?
Timing Belt; replace at 80k (Check Injection Pump Timing after replacing belt)
Injection Pump Timing; Set at 7* w/ engine off
Engine/Tranny mounts; (only avail. from Japan?)
Clean Battery Terminal;
Brake Pad Replace; (if below 40%) Front: Raybestos, PGD349C ('90 Montero)
Rotors Machined;
Front Wheel Bearing / HUB Re-Grease;
Torsion Bars; check/adjust
Alignment;
Ball Joint; (Check / Replace)
Tie Rods / Steering Link; (Check / Replace)
Sway Bar Bushing; (replace)
All Suspension Parts; regressed.
Shock Absorber Inspection; (Check / Replace)
Coolant Flush; (Radiator Rebuild if Necessary)
Engine Flush;
Oil; Chevron Delo 400 15W40 (6.5L with new filter) or Esso XD3 15W40
Power Steering; Fluid Flush
Clutch Fluid; Flush
Brake Fluid; Flush
Gear Oil;
Differential Oil;
Transmission Fluid;
Thermostat; (Check/Replace)
Water pump; (Check/Replace)
Radiator Cap; (Check /Replace)
Power Steering Belt;
Alternator Belt;
AC Belt;
Air filter; (or K&N filter 38-9207); replace
Fuel Filter; Change
Oil Filter; Change (FRAM> PH6355 or NAPA> 1067)
Change Muffler or Pipes when needed.
New Wipers Installed
All Hinges Greased
All compliance items (headlights, DRL, reflectors...)
Is it worth to do undercoating for rust prevention?
What am I missing and where am I wasting my time (and $$$) ???
Thanks,
D.
EGR; clean or block
Turbo Pressure; check
Tires; DOT, 235x75x15 (or 30"x9.5x15)
(If I wish to get tall and narrow tires, what would you suggest?)
Tranny oil: Take out pan, put new gasket & strainer metal filter ($25-30, '90 Montero kit),
use Destron 3 oil from Toyota (every 20-25K) How much is needed?
Timing Belt; replace at 80k (Check Injection Pump Timing after replacing belt)
Injection Pump Timing; Set at 7* w/ engine off
Engine/Tranny mounts; (only avail. from Japan?)
Clean Battery Terminal;
Brake Pad Replace; (if below 40%) Front: Raybestos, PGD349C ('90 Montero)
Rotors Machined;
Front Wheel Bearing / HUB Re-Grease;
Torsion Bars; check/adjust
Alignment;
Ball Joint; (Check / Replace)
Tie Rods / Steering Link; (Check / Replace)
Sway Bar Bushing; (replace)
All Suspension Parts; regressed.
Shock Absorber Inspection; (Check / Replace)
Coolant Flush; (Radiator Rebuild if Necessary)
Engine Flush;
Oil; Chevron Delo 400 15W40 (6.5L with new filter) or Esso XD3 15W40
Power Steering; Fluid Flush
Clutch Fluid; Flush
Brake Fluid; Flush
Gear Oil;
Differential Oil;
Transmission Fluid;
Thermostat; (Check/Replace)
Water pump; (Check/Replace)
Radiator Cap; (Check /Replace)
Power Steering Belt;
Alternator Belt;
AC Belt;
Air filter; (or K&N filter 38-9207); replace
Fuel Filter; Change
Oil Filter; Change (FRAM> PH6355 or NAPA> 1067)
Change Muffler or Pipes when needed.
New Wipers Installed
All Hinges Greased
All compliance items (headlights, DRL, reflectors...)
Is it worth to do undercoating for rust prevention?
What am I missing and where am I wasting my time (and $$$) ???
Thanks,
D.