Page 1 of 1

clunking front end

Posted: Sat Jul 05, 2008 10:14 pm
by rdub
Lately when driving on the logging roads the front end dose not feel solid,its clunking when driving over the smaller bumps,washboard,it feels like my front end is loose in the wheels. Im thinking the stearing arms are worn out cause i feel it in the steering wheel,it's not solid and is really clunking. this seems to be getting worse also when turning to the right there seems to be some noise also like worn bearing, but its not hot and not a grinding noise? .....new shocks and bushings have been done.

Re: clunking front end

Posted: Sun Jul 06, 2008 11:30 pm
by username
take a look, maybe you have lost a bushing or two. i had a terrible clunk while going on rough roads, then i discovered one of the bushings was gone, i replaced it and it clunks no more.

Re: clunking front end

Posted: Mon Jul 07, 2008 7:40 am
by jessef
Sway bar bushings
Ball joints

Jack up your front end. Grab the wheels (top and bottom) and wiggle in and out and check for play.

Re: clunking front end

Posted: Mon Jul 07, 2008 4:04 pm
by sid
also check your lower control arm bushings. they will clunk if they are loose or worn out. there is 2 on each side. worth a check.

sid.

Re: clunking front end

Posted: Thu Jul 10, 2008 2:33 pm
by rdub
Looks as though i may have a worn out ball joint ,drivers side,there is in and out play at the joint that links the control arm (not the joint at the hub assembly)the boot is split and this must be the problem .....Mardy $$$$,what am i looking at for a new one.and it looks like its not a fun job ,and or can i adjust the nut at the hub area to tighten it in?
Rdub :M

Re: clunking front end

Posted: Thu Jul 10, 2008 4:04 pm
by rdub
Heres the deal. (problem) :?