Licence plate mod
Posted: Sun Feb 01, 2009 1:25 pm
I can not count anymore how many times I fixed the bent licence plate after we came back from the backcountry.
Here is an easy modification I did last wee:
1. Cut the two brackets in half and remove the metal from the licence plate holder.
2. Cut and bend little brackets on the remaining piece of metal.
3. Screw the licence plate holder onto the bracket on the bumper. Done
The licence plate is now much closer to the bumper and will not touch ground in a deep ditch
Here is an easy modification I did last wee:
1. Cut the two brackets in half and remove the metal from the licence plate holder.
2. Cut and bend little brackets on the remaining piece of metal.
3. Screw the licence plate holder onto the bracket on the bumper. Done
The licence plate is now much closer to the bumper and will not touch ground in a deep ditch