Page 1 of 1
ECM REPAIR
Posted: Sun Jan 24, 2010 9:54 pm
by skippyalbright
Anyone have any recommendations for ECM repair in Calgary? Some of the components on the board need to be replaced and a tracing needs to be resoldered.
Phil
Re: ECM REPAIR
Posted: Sun Jan 24, 2010 10:10 pm
by marsgal42
If you mean the glow plug controller, anybody who knows which end of a soldering iron to pick up can fix it.
...laura
Re: ECM REPAIR
Posted: Sat Feb 06, 2010 1:31 pm
by Erebus
marsgal42 wrote:If you mean the glow plug controller, anybody who knows which end of a soldering iron to pick up can fix it.
I'm not bad with a soldering iron, but I don't go near circuit boards. Green1's a lot better at than I.