Page 1 of 1
shampoo motor's WVO install by After Oil
Posted: Sun Jul 25, 2010 7:23 am
by after oil
i did an install very much like mine recently. a good friend bought the van from me then hired me to install the same wvo system that my van runs. i am finallly getting around to posting the photos....
the filter
the switch
the heat exchanger/valve and the relays. the relays are for the glow plig inthe heat exchanger, and the assist pump
the filter head installed behind the battery compartment
the WVO assist pump
the heater hoses TEEd in
the filter installed
new filler hole for tank
return valve, at bottom of photo, and site filter...
cutting the filler hole
i cant seem to find the resit of the photos
this will do for now!
Re: shampoo motor's WVO install by After Oil
Posted: Sun Jul 25, 2010 7:30 am
by after oil
here are some more photos.. i dont seem to have one of the heat exchanger with all the hoses attached, but i think you get the idea...
the filler hose:
the filler cap
Re: shampoo motor's WVO install by After Oil
Posted: Mon Jul 26, 2010 12:01 am
by delicat
Nice work!
Should be nice not to have to deal with the install and just drive away on veggie! It's nice to say you've done it all by yourself but "T"ing some of those coolant/fuel lines, cutting some of those sheet metals... can be a real pain in the ass.
Nice to see you've used one of the stock tank for the veggie, saves on building another tank. How does it go with the fuel gauge?
Keep on converting them After Oil, there can never be enough of them on the road!
Cheers,
David
Re: shampoo motor's WVO install by After Oil
Posted: Mon Jul 26, 2010 12:30 am
by BCDelica
Nice Ari, but using a hoist............. that's cheating.
The fuel gauge will average the two tanks likely, or did you wire a resistor to the diesel tank sender to use just the Veggie tank with the gauge?
ChocdeeCap,
Kev
Re: shampoo motor's WVO install by After Oil
Posted: Mon Jul 26, 2010 7:17 am
by after oil
i didnt touch the fuel guages. we have BCDelicas old van kicking around as a for instance.
the install went well, but there is a slight pulsing of RPM when starting on WVO that clears itself after a minute. that vehicle is on its way to shambhala near nelson right now, as a real test!
Re: shampoo motor's WVO install by After Oil
Posted: Mon Jul 26, 2010 10:55 pm
by dfnder
On my computer none of the pictures loaded :(
Re: shampoo motor's WVO install by After Oil
Posted: Tue Jul 27, 2010 6:14 am
by Artacoma
Funny ..... pics loaded fine fine yesterday but wont this morning......
Re: shampoo motor's WVO install by After Oil
Posted: Tue Jul 27, 2010 7:14 am
by after oil
im not sure why they wont load, i cant even see them on the page they are uploaded too. ill check it out later