Delica Canada | Mitsubishi Van Club

Ive got some play in the front passenger side wheel bearing. I need to find some new bearings going to do both sides. Does anybody know if montero parts are interchangeable? or any easy access part numbers?

Thanks

It will depend on options if that is the correct part # or not. On some vans you may need to replace both sides (ie the wiper control and signal switch) as it is one unit or you might be able cannibalize a new switch for parts. Easy enough to figure out but mine was expensive as I did not find this ...

Does any one have the part number for this? I am hoping the montero one may swap in as the price is much more reasonable.

Thanks

We were driving up to the ski hill yesterday in poor conditions so I was watching the road as opposed to the dash, when i glanced down our speedometer was at 0km/h we were likely going about 50-60 km/hr. I was still busy driving so didn't look down again for about 1 min and when I did speedometer wa...

P.Gaudreault wrote:I have the same oïl leak with my 1998. Thank for all these good info. Is It possible that this leak make the engin cough at a different speed? Like all the van is shaking.

The leak gets worse quickly, order parts and repair asap, check/add oil every time you drive the vehicle until repaired.

q1- Coldest successful start completely unassisted was -32oC plus wind chill we did not want to get out of our sleeping bags but she started. (should of left her idling through the night)has never not started when block heater was plugged in. We have had a few no starts at -25--30oC when no block he...

p.s. shopping for a NA market vehicle has me feeling all warm and fuzzy again about our van, these things really are that good.

I am shopping for a full sized pick up to put a camper on. The Delica is just too small for a family of 4 too sleep in and carry gear, it will remain as our daily driver and we still love it after 7yr and 150000km. In my research I've read about checking for blow by on the diesel trucks as a possibl...

All done, leak is cured.

Parts just arrived and getting dark outside will have to wait until friday. Old sensor needs a 1 1/8" deep socket (will have to borrow one, new one from mardy fits in a 24mm deep socket

Thanks again.

Thank you, does the fix just involve removing the old sender and threading in the new one and reattaching the wire? What causes them to break? I have the new part on the way.

Our 1996 l400 recently sprang a leak from what i think is the vacuum pump (passenger side of the engine compartment on the front of the motor with a line running to the brake booster). It appears that the top piece is broken off? Does anybody have any insight? What is the black plastic part that loo...

Got it bypassed, now just looking for a core to put in, wary of a used one as this is apparently an un-enjoyable process.

$350-399 for a new one from the dealer in bc. There may be some used ones available still have to check a few more online sources.Thanks for the info.