More of an experience than anything else. So I was driving my 97 Active World, it was a bit of a rough gravel road, and I hit a deep pot hole. When I did the Inclinometer Pod removed itself from the dash, making a sound of shattering plastic. The parts around the screw are still attached but broken from the Pod.
I'm going to try and collect all the pieces and JB weld them together again, but has anyone else experienced this? BTW, nothing else noticeably wrong.
Inclinometer Pod
-
- Posts: 12
- Joined: Sat Oct 07, 2017 7:00 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica Star Wagon Active World '97
- Location: Toronto
-
- Posts: 3
- Joined: Thu Jul 05, 2018 5:32 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Vera, a 1999 Chamonix
- Location: London, ON
Re: Inclinometer Pod
Good luck with the JB job. My next small project to tacke is fixing my incimeter ball.
-
- Posts: 3
- Joined: Fri Jun 26, 2020 8:36 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 L300 Delica
- Location: ALCOA
Re: Inclinometer Pod
put your pcs together and get it scanned and see if someone can 3d print you one... then find someone who does plastic welding. Likely however it busted because of age and it will not work but just break again... sorry