Delica Canada | Mitsubishi Van Club

Are these plug and play or do you need anything extra to install them?

I am also looking to share some of that Costco floor.
I just got the costco magazine and its on sale from coscto online for 139 delivered.....

email me at dave_brim "at" hotmail dot com

PM sent

DOnt know if this is a repost, but its amazing enough to warrant a second look!

http://www.flixxy.com/ural-4320-off-road-6x6-truck.htm

jaggedfish: Both are correct. My wife has a wicked MS Paint habit, as such I did find this in one of her files!

If someone's making shirts, I'll take an XL and a Small

All I ask is that if you get it printed, send me a pic of the result :)

-Dave

Soooooooooooooooooo

I was browsing through the computer when i found this little Gem......

-Dave

Im excited to check out CC Auto in Combs! Whenever I've had a problem they've offered sane and helpful suggestions, plus all ive heard is positive feedback from their customers :)
It'll be quite nice to be within an hour of a Deli shop in stead of 1500k!

Hey hey, Be nice now.
I happen to be in the Air Force, working on fighter jets.

BUT, just got my transfer to Comox so its back to BC finally.

Ive got my shop here to order a tie rod from CVI and he's (as always) been an excellent help!

-Dave

Hey All, I'm looking for some advice from the people who have dealt with anything similar. I need an alignment done, and new tires. I went to the local shop up here in Cold Lake, AB and they said that I have a loose inner right tie rod and that my steering rack is a little sloppy. I am about to move...

Hey hey,

Im up in northern Alberta, what would shipping be like on one of the 1/4 blanking plates?
or, I work in an Aircraft Machinist shop and could fabricate my own if someone would be kind enough to send me a copy of the drawing :)


-Dave

I tried moving the tube around, removed the bracket but still couldnt get it to fit. Then the light came on and i realized that my block heater was in direct conflict with the oil tube. Sooooooooooo, 30 minutes later on my tube bender at work i rerouted the oiltube around the blockheater and it now ...

Thanx FS,

Did your new starter fit?

I got my old one out but cant find the room to get the new one in. Side by side the new starter is just a curly hair longer and fatter (about 1/8") but it is stubbornly refusing to go in. The new one bumps up against the oil dipstick tube.

Hey All,

Im finally ready to replace my starter on my L300 Jasper, got a new one from Butch @ CVI.

Anyone familiar with this job? Is there anything i need to remove to gain access to it?

-Dave

I checked the batteries, there are both deep cell and in good condition :)