Delica Canada | Mitsubishi Van Club

Nice!

I have thought of doing that and using a low profile door handle from some junker.

Still, yours is operational and I don't have one....

Sounds like it works well when you have air blowing over the fins - or - that the compressor works well at higher RPM, but not at idle.

Try it parked at higher RPM.

Your compressor may be on the way out.

here it is what it looks like, contrasted with the original air ram.

http://imgur.com/DL8HCDZ
http://imgur.com/CRE7Dhk
http://imgur.com/LGobm2m
http://imgur.com/DLaXxzR

You could always add in an intercooler like Growlerbeans did.

You could always add in an intercooler like Growlerbeans did.

You could always add in an intercooler like Growlerbeans did.

I just got the snorkel head from China. It seems pretty good actually. I will try to remember to post some photos later.

It fits perfectly into my L400 snorkel. The RAM snorkel that came with it fits on outside the snorkel, the dust-trap/cyclone head fits perfectly inside the barrel of the snorkel.

When the contacts on the door close, the motor starts up and pulls the door inward. This allows you to close the door very quietly and without slamming it.

Often the contacts get dirty where the door closes, and if you clean them the motor starts working again.

I experienced a similar only cranking when connected to an external power source (booster/car). It turned out to be the ground wire. Trace it from block to body to battery 'Y'. Hope it works for ya Hey, what are you doing back on here? :-D Threadjack I still need to find out exactly which outfit yo...

Welcome! You came to the right place! :)

I just ordered the $35 cyclone snorkel head. I will probably use the RAM head most of the time, but if Mt. Rainer goes all asplodey, then I will want to have the cyclone on.

Just finished powder coating http://s21.postimg.org/565syzaoj/20160310_185346.jpg http://s8.postimg.org/blihem31t/20160310_185356.jpg Does anyone know where i can either get or think of something i can use to seal the hole and finish the look of the hole i cut in the van. Im not sure where to get a...

D.Rock wrote:Hey Flibble,
Where do you get you parts here in the states? I'm looking for a valve cover gasket and some filters.

Thanks,
D

I order most of my parts out of BC - Coombs Country Auto usually. The exchange rate is really good right now, though the shipping balances it out. Glenn is a good guy.

Hopefully your 25 year old Deli isn't more than $10,000. I believe the import fee was 2 or 3% of the "stated" purchase price. You and the seller can "state" the "price" you "settled" on and then put it on the paperwork. Well given that I already own it, that'...

Nice!

No bushbar on yours?