Sliding door won't open

Mitsubishi Delica L400 production commenced in 1994 -- After much anticipation, the L400 arrived on Canadian Soil in 2009!
legionnair
Posts: 279
Joined: Fri Aug 26, 2011 7:05 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: delica L300
Location: van island

Re: Sliding door won't open

Post by legionnair »

I work for BC Transit and side work a little. As suggested above you could switch your front tires to the rear and see if the shimmy moves to you steering wheel. If it doesn't then you know its a rear end, rear shock or rear drive shaft. Is this a new vehicle to you?

Rereading your other posts you said it goes away when going down hill, does it get worse if you going up hill or accelerating hard?


Dustin
Measure it twice, cut once. Dam still cut wrong
johnnyrigs
Posts: 28
Joined: Sun Mar 04, 2012 5:34 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica
Location: Vancouver

Re: Sliding door won't open

Post by johnnyrigs »

It does get worse on an uphill, drove to Seattle a while ago and noticed more shimmy on a steeper hill
johnnyrigs
Posts: 28
Joined: Sun Mar 04, 2012 5:34 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica
Location: Vancouver

Re: Sliding door won't open

Post by johnnyrigs »

I bought it about 8 months ago from this guy Brad and it's been nothing but problem after problem, he talked a good game and I put my faith in him but he took me for a ride.... I had the injector pump rebuilt $1000 among other things and I just dropped $6000.00 getting the corrosion out of the frame and welded. I'm too far in now to give up, I do love the van but I hope this shimmy won't ruin me, I've got 2 babies that cost a lot and I don't know if my bank account can handle another big expense
johnnyrigs
Posts: 28
Joined: Sun Mar 04, 2012 5:34 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica
Location: Vancouver

Re: Sliding door won't open

Post by johnnyrigs »

On a positive note, my sliding door is fixed...LOL
legionnair
Posts: 279
Joined: Fri Aug 26, 2011 7:05 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: delica L300
Location: van island

Re: Sliding door won't open

Post by legionnair »

Crawl under and give the drive shaft and slip joint a good up and down wiggle u-joints should have zero and the slip joint might have a tiny bit. Try and grease them and drive it see if it is better.

Hard to do much from behind a computer

Dustin
Measure it twice, cut once. Dam still cut wrong
johnnyrigs
Posts: 28
Joined: Sun Mar 04, 2012 5:34 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: Delica
Location: Vancouver

Re: Sliding door won't open

Post by johnnyrigs »

Hey Dustin, think you might want to help me out with this when you have time? email me
legionnair
Posts: 279
Joined: Fri Aug 26, 2011 7:05 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: delica L300
Location: van island

Re: Sliding door won't open

Post by legionnair »

QPm'ed
Measure it twice, cut once. Dam still cut wrong
Post Reply

Return to “L400 Technical”