My paj arrived with Piaa hi/low aux lights, they were intact except the control switch of course was missing. Now this series of lights is obsolete so parts are not available. They are high/low lights using a H4 bulb, wiring for the switch(two wires,no power) comes out between the power(battery) and the relay(PL1F) and runs into the interior where it is wired into the switch wiring which also is wired to a live and a ground to power the light for the LED switch.
My question to all the electronic experts out there, is there a switch that will work with the Piaa system? Piaa wanted to sell me a complete harness for $165.00, that was the only solution they had other than a cheaper harness ($49.00) that would have to be rewired and give me one beam. It would be good that since I have the Piaa system that I could actually get it to light up
