Wheel studs for 91 Mitsu Delica 4x diesel
Wheel studs for 91 Mitsu Delica 4x diesel
Has anyone replaced the wheel studs and if so do you have a part # or size and thread pitch (I assume front and rear are the same)?
-
Erebus
- Posts: 1369
- Joined: Mon May 28, 2007 7:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Super Exceed
- Location: Edmonton, Alberta
- Location: Edmonton (was Calgary until 2017), Alberta, Canada
- Contact:
Re: Wheel studs for 91 Mitsu Delica 4x diesel
Never done it on a Delica. Did it several times on an 82 Subaru (too much fun offroading), and the dealer never had a problem. Given that I've never heard people discussing wheel nuts, I would guess that the thread size and pitch are standard. Not sure about the rest of it though.
"I could be just around the corner from heaven, or a mile from hell." -- Jackson Browne, "The road and the sky".-
PolyTek
- Posts: 103
- Joined: Fri Sep 28, 2007 1:18 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica P35W Exceed 5MT
- Location: Lower Mainland, BC
- Location: Port Coquitlam, B.C., Canada
- Contact:
Re: Wheel studs for 91 Mitsu Delica 4x diesel
It's a pretty standard pitch/thread. I changed over the wheel locks from my Toyota van, same fit excactly.
D
D
The world is my oyster; tasty, yet often full of sand.