The lap belts in my 91 l300's captains chairs dont seem to lock at all there is no racheting action at all....just wondering if they need replacing as I dont see how they would work in a accident. Any ideas?
Thanks
Joe
91 l300 captains chair seat belts
-
- Posts: 329
- Joined: Wed Sep 30, 2009 4:21 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 94 Pajero
- Location: Prince George BC
- Location: Prince George BC
-
- Posts: 329
- Joined: Wed Sep 30, 2009 4:21 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 94 Pajero
- Location: Prince George BC
- Location: Prince George BC
Re: 91 l300 captains chair seat belts
I guess my main question those with lap belts on the captains chairs do they lock when pulled quickly? Like standard seat belts?
Thanks
Joe
Thanks
Joe
Re: 91 l300 captains chair seat belts
There is a post on this site somewhere that goes into great detail on how they work. I know they are different than your typical lap belt as they do not ratchet. It works on some type of inertia mechanism but I'm not sure how. All I know is that they won't be any good for car seats as you can't make them tight to hold the car seat which I'm sure you've already figured out.
-
- Posts: 329
- Joined: Wed Sep 30, 2009 4:21 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 94 Pajero
- Location: Prince George BC
- Location: Prince George BC
Re: 91 l300 captains chair seat belts
Thanks Ill do some searching...for now I have the car seats on the back bench seat amd actually it works pretty good for now. Just wondering about the safety of other passenger's.
- Growlerbearnz
- Posts: 2041
- Joined: Sat Jun 26, 2010 1:58 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: Delica P25W
- Location: New Zealand
Re: 91 l300 captains chair seat belts
Japanese rear seatbelt standards from the '90s were a bit weird. I've seen belts that are webbing-sensitive (locks up if the belt is pulled out too fast), inertia sensitive (locks if it senses g-force, like a car decelerating), and belts which have both mechanisms.
Sounds like you may have inertia sensitive belts- they should lock if you tilt the reel by about 30 degrees or park on a steep slope (or, obviously, if you're braking).
Sounds like you may have inertia sensitive belts- they should lock if you tilt the reel by about 30 degrees or park on a steep slope (or, obviously, if you're braking).
Nothing says "poor workmanship" more than wrinkles in the duct tape.
-
- Posts: 329
- Joined: Wed Sep 30, 2009 4:21 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 94 Pajero
- Location: Prince George BC
- Location: Prince George BC
Re: 91 l300 captains chair seat belts
Thanks everyone
The seats belts work just fine ☺. Tested them and they do lock, just slid the seat back quickly while pulling on the belt and it locked right up.
The seats belts work just fine ☺. Tested them and they do lock, just slid the seat back quickly while pulling on the belt and it locked right up.