tires
-
Firesong
- Posts: 1363
- Joined: Tue Feb 03, 2009 9:03 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1998 L400 Delica Chamonix
- Location: Saskatoon
- Location: Saskatoon, SK. Canada
Re: tires
I am looking at these to buy used
Rims and tires from a Nissan Pathfinder 6 bolt pattern
265/70R15 MIC X-Ice Latitude BW 112Q
A tire size calculator shows that they would be:
9.25" (stock width) to 10.24"
28.8" diameter to 29.6"
Will they fit an unlifted L300 deli?
Bolt pattern and no rubbing?
It would be nice if I could just bolt them on and ware the rubbing?
J
Rims and tires from a Nissan Pathfinder 6 bolt pattern
265/70R15 MIC X-Ice Latitude BW 112Q
A tire size calculator shows that they would be:
9.25" (stock width) to 10.24"
28.8" diameter to 29.6"
Will they fit an unlifted L300 deli?
Bolt pattern and no rubbing?
It would be nice if I could just bolt them on and ware the rubbing?
J
Last edited by Firesong on Fri Nov 20, 2009 8:09 am, edited 1 time in total.
-
Erebus
- Posts: 1369
- Joined: Mon May 28, 2007 7:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Super Exceed
- Location: Edmonton, Alberta
- Location: Edmonton (was Calgary until 2017), Alberta, Canada
- Contact:
Re: tires
Not likely. The stock rims are 15" so 16" tires would be just a tad loose.Firesong wrote:Hi
I have the stock aluminum rims for my l300
I think I have 235...'s on it.
Can these tires fit the rims?
245/75/R16
"I could be just around the corner from heaven, or a mile from hell." -- Jackson Browne, "The road and the sky".-
jessef
- Posts: 6459
- Joined: Tue Feb 26, 2008 1:27 pm
- Vehicle: JDM flavour of the month
- Location: Vancouver
- Location: Vancouver, BC
Re: tires
I sent you a pm.
If they are on stock nissan rims they may fit. You'll have to remove the front mud flaps and may need to lift the front end up via torsion bar if it's sagging
If they are on stock nissan rims they may fit. You'll have to remove the front mud flaps and may need to lift the front end up via torsion bar if it's sagging