L400 interior trim

[DeliTan]

Hi Folks;

Well I started to do the install of a back up cam and got stumped pretty early. I released the clips on the rear door lower trim but the "pull down strap" is holding the trim on. I'm sure the plastic bit will reveal a screw once removed but how do I get it off without damage?

Once I am in the door, I will decide whether to install the camera in the keyhole or not. I will also get power for the camera from the back up lights

Thanx

john

[Green1]

As the general consensus appears to be that I do not know what I'm talking about, and cause more harm than good, I am removing this post so that others are not tricked in to following my ill-advised instructions.

[DeliTan]

Thanx Green1. That and a pic I found here

http://imageevent.com/russpix/photos/tailgateconversion

did the trick

That was a very stressful 8 second wait for a response tho'



john

[Green1]

That was a very stressful 8 second wait for a response tho'

sorry... I'll try to be faster next time...