stock intercooler

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
User avatar
Tinytoy
Posts: 141
Joined: Mon Jul 27, 2009 8:14 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 90 Suzi Carry, 91 Safari
Location: Saskatoon
Location: Saskatoon,Sk

Re: stock intercooler

Post by Tinytoy »

Tehehehe, My 710 sticker always ends up upside down :-( 10L looks so unsophisticated 8-)
Thanks for soaking my screen with coffee Falco!
If at first you don't succeed , get a bigger hammer.
User avatar
Erebus
Posts: 1369
Joined: Mon May 28, 2007 7:55 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1992 Super Exceed
Location: Edmonton, Alberta
Location: Edmonton (was Calgary until 2017), Alberta, Canada
Contact:

Re: stock intercooler

Post by Erebus »

FalcoColumbarius wrote:
  • The big rad in front of the engine is the main engine rad, which everyone seems to agree on.
  • The radiator protected by the front left foot bars is the main A/C condenser.
  • The one protected by the front right foot bars is for the automatic transmission.
  • The one up in behind the bambie bars (under the shroud) is for the 710 solution.
  • I believe the little condenser mounted on the main rad is for the cabin A/C.


Falco.
I would swap 2 and 5. The one in front of the main radiator is the A/C condenser, the one under the left front steps is the rear A/C condenser. Good one with the 710, though, I didn't understand that one. Hey, it's before noon, I don't think so well then.
Image "I could be just around the corner from heaven, or a mile from hell." -- Jackson Browne, "The road and the sky".
Post Reply

Return to “L300 Technical”