Strange Noise and Vibration

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
MrDuncon
Posts: 100
Joined: Sun Jul 29, 2007 12:14 pm
Vehicle: '95 L300
Location: Hungary

Strange Noise and Vibration

Post by MrDuncon »

Hello my Canadian Friends!

Long time ago i had a small vibration when i accelerate or carry a heavier payload, around 1800RPM.

Few days ago i drowe across a deeper but even clean water (0,75m) and this vibration intensified with strange noise.
I just accelerate hardly cos the intensive vibration...

Luckily my repairman solved the problem rapidly.
And the reason of the fault: Universal-Joint Center Cross (Cardan- Joint)

It was a near thing:
ST833166.JPG
ST833166.JPG (52.73 KiB) Viewed 2680 times
ST833165.JPG
ST833165.JPG (60.3 KiB) Viewed 2682 times
Well, be carefull with these parts (You have 4 on a 4WD Delica),
if you have a free afternoon check these parts and grease them.
(the cross on the pics is not slushable)
Sorry for my English
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Photo blog: zoltansz.tumblr.com
Blog: jdmjinsei.com
User avatar
mararmeisto
Posts: 3276
Joined: Wed Sep 19, 2007 10:00 am
Vehicle: 2018 Ram EcoDiesel
Location: Dartmouth, NS

Re: Strange Noise and Vibration

Post by mararmeisto »

Well, one can definitely tell where the wear was! Good thing you went through that second bit of water.

This incident is testament to a greasing routing, especially if you're crossing creeks and streams. Submerging parts into water really is different than just getting it wet from spray (like driving in the rain).
JPL
I still miss my '94 Pajero!
riverdeli
Posts: 2
Joined: Thu Jul 03, 2008 11:11 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: 1991 Delica exceed

Re: Strange Noise and Vibration

Post by riverdeli »

hello guys i am going through that same problem right now. the importace of constant lubing hey.
I think these are going to need allot i just repaced mine in june and now they have blown again only 10,000 km later.
MrDuncon
Posts: 100
Joined: Sun Jul 29, 2007 12:14 pm
Vehicle: '95 L300
Location: Hungary

Re: Strange Noise and Vibration

Post by MrDuncon »

Maybe your cardan-shaft is not weighted correctly.
I have a weight (like on wheels) on my cardan...
So if this is damaged your shaft will shake the spiders/crosses always when its spinin..
Sorry for my English
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Photo blog: zoltansz.tumblr.com
Blog: jdmjinsei.com
Post Reply

Return to “L300 Technical”