no problem ,it will be smooth!
Looking for a Skid Plate for my L300
Moderator: BCDelica
-
fishslapper
- Posts: 356
- Joined: Wed Oct 10, 2007 12:48 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1994 lwb l400
- Location: ottawa ontario
- Location: ottawa ont
Re: Looking for a Skid Plate for my L300
I like smooth too !!!!
no problem ,it will be smooth!
no problem ,it will be smooth!
The Mighty Boosh !!
-
Mr. Flibble
- Posts: 1397
- Joined: Tue Nov 03, 2009 7:31 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1995 L400 Royal Exceed
- Location: Issaquah, Washington
- Location: Issaquah, Washington
Re: Looking for a Skid Plate for my L300
Any chance of you peeking over at the thread about the L400 skid plates? *hint* *hint*fishslapper wrote:I like smooth too !!!!
no problem ,it will be smooth!
Canadian living in Washington USA
-
Meanman
- Posts: 342
- Joined: Sun Dec 07, 2008 5:27 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1990 Exceed Crystal lite
- Location: Maple Ridge
Re: Looking for a Skid Plate for my L300
[quote="fishslapper"]I like smooth too !!!! quote]
Are we still talking about skid plates?
quote]Are we still talking about skid plates?
YOUTH JUICE YOUTH JUICE RESTOR
The Goodness of 7 Pounds of Whole Berries+ 3 Sea Vegetables in Every Bottle
http://www.jhallen.youthjuice.com
The Goodness of 7 Pounds of Whole Berries+ 3 Sea Vegetables in Every Bottle
http://www.jhallen.youthjuice.com
-
Spearo
- Posts: 279
- Joined: Mon Jun 08, 2009 3:03 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 Smellica Exceed
- Location: Edmonton
- Location: Edmonton
Re: Looking for a Skid Plate for my L300
Smooth would be cool.
"I tell you, we are here on earth to fart around, and don't let anybody tell you different" - Kurt Vonnegut
-
Erebus
- Posts: 1369
- Joined: Mon May 28, 2007 7:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Super Exceed
- Location: Edmonton, Alberta
- Location: Edmonton (was Calgary until 2017), Alberta, Canada
- Contact:
Re: Looking for a Skid Plate for my L300
Well, if jwfchase posts one of the skid plate in good weather, here is one hard at work:
I did have to modify mine slightly. The upper piece -- the only part visible -- I had bent a little more, so it is more vertical. That way it clears my foglights that are mounted behind that round bar that is part of the bullbars. It is the bend just below the diamond-shaped cutouts that needed to be increased.
- SkidplateSnow3937.jpg (99.67 KiB) Viewed 3376 times
"I could be just around the corner from heaven, or a mile from hell." -- Jackson Browne, "The road and the sky".