Air filter and gas struts

[dasein]

Hi all-

The K&N number on the parts list does not work in my van. It fits, but the stock filter has a closed end and seals around the middle of the airbox, while the K&N seals on each end.

Does anyone have a better part number?

Second, I am looking to replace my gas struts on the rear door. Any advice appreciated.

Thanks,
Jay.

[madmazda]

what year and model delica do you have with which engine ???

[dasein]

94 L400 2.8

[EnviroImports.com]

I had the same issue with the air filter, i had to make a top and bottom plate to make it work, you can do it, but some mods need to be made, I honestly dont think the model number should be listed as its not a good fit and allows to much unfiltered air into the turbo... I did post about it, but it gets bumped down fast...

[danfromvan]

Re: rear door gas struts, Mardy was selling some a while back but I think they were for an L300.

The other alternative is Strut-Wise in Surrey:

Frank Irvine 604 589-1200 or 1 888 589-1208 http://www.strutwise.com - 14468 - 88 Avenue, Surrey in the lane south of 88.

Excellent work re-gassing them like new and 1-2 day turnaround. He was charging about $120/pair for delica.ca members when I got mine done last March. My door still stays up full height with a ladder on.

[dasein]

Thanks Dan. This sounds like the solution.

[danfromvan]

You're welcome. I sent you a PM.

[Artacoma]

Just got my struts regassed at Strutwise , was a little droopy after installing my ladder, it cost $65 per strut.
Very happy with their service , nice guys and fast.
Now I have to duck out of way when I open the hatch ....it's catapult like

[gtexjunkie]

I am dropping mine of tomorrow. Should be a nice improvement over the droopy head smasher.

[fexlboi]

The other alternative is Strut-Wise in Surrey:

Frank Irvine 604 589-1200 or 1 888 589-1208 http://www.strutwise.com - 14468 - 88 Avenue, Surrey in the lane south of 88.

Excellent work re-gassing them like new and 1-2 day turnaround. He was charging about $120/pair for delica.ca members when I got mine done last March. My door still stays up full height with a ladder on.

Thanks for the info. I dropped mine off today. Frank is a really nice guy.