blanking plate

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
User avatar
rdub
Posts: 261
Joined: Wed May 23, 2007 7:18 pm
Member's Photo Album: http://www.delica.ca/Photos/
Location: aldergrove

blanking plate

Post by rdub »

whats its main purpose ,iv been reading the forum searching for answers to my problem,i have a slight ticking sound @ start up then goes away in about 20 seconds never to be heard of again till the van cools down and i state er back up, injectors ,egr ,unicorns, im not to sure maybe valves it sounds like its going through rotation a little when ticking ? :|
I am stable in most situations that I have no reservations in stormy conditions.
User avatar
Jungle Jon
Posts: 237
Joined: Wed Nov 22, 2006 12:46 pm
Vehicle: Toyota Tacoma
Location: Calgary, AB, CA

Re: blanking plate

Post by Jungle Jon »

Hi rdub,

Are you asking about the EGR blanking plate? The EGR valve recycles some of the hot exhaust gas back into the engine air intake, and over time it can get gummed up and stick, causing black smoke. You can either take it out and clean it, or some like to block it off altogether with a blanking plate. There's lot of discussion here and on the other Delica and Pajero forums on whether or not a blanking plate is a good idea, just search for "EGR" and "plate" to read the debate.

As for the ticking sound, if it sounds like it's coming from behind you, that's just the glow plug relay, it cycles the glowplugs on a few times after starting cold. Nothing to worry about. 8-)
User avatar
mdrive
Posts: 528
Joined: Tue Nov 07, 2006 3:09 am
Member's Photo Album: http://www.delica.ca/Photos/
Location: Richmond, BC
Contact:

Re: blanking plate

Post by mdrive »

It is the glow plug relay making the ticking noise so leave it the way it is.
Image
MAXIMUM OVERDRIVE AUTO IMPORTERS
4-7900 RIVER ROAD, RICHMOND, BC V6X1X7
TEL: 604-726-3109 Email: Sales@maxoverdrive.ca
For Vehicles visit: http://WWW.MAXOVERDRIVE.CA
For Online Parts Store, visit:http://www.maxoverdrive.ca/parts/.
User avatar
rdub
Posts: 261
Joined: Wed May 23, 2007 7:18 pm
Member's Photo Album: http://www.delica.ca/Photos/
Location: aldergrove

Re: blanking plate

Post by rdub »

If its the glow plug relay that is making that ticking why has it just started to do it? i know that when the glow plugs are hot enough they make a click letting you know that there ready ,but the ticking is lasting 20 to 30 seconds. i also seem to be blowing a little more smoke than normal ,i was thinking that if its a valve tic that it may be exhaust?
I am stable in most situations that I have no reservations in stormy conditions.
User avatar
mdrive
Posts: 528
Joined: Tue Nov 07, 2006 3:09 am
Member's Photo Album: http://www.delica.ca/Photos/
Location: Richmond, BC
Contact:

Re: blanking plate

Post by mdrive »

Still I think it the glow relay. The Glow Relay ECU creates a problem when it is old as the resistors in the ECU don't function properly. If you rev it for few seconds, does it go away?
Image
MAXIMUM OVERDRIVE AUTO IMPORTERS
4-7900 RIVER ROAD, RICHMOND, BC V6X1X7
TEL: 604-726-3109 Email: Sales@maxoverdrive.ca
For Vehicles visit: http://WWW.MAXOVERDRIVE.CA
For Online Parts Store, visit:http://www.maxoverdrive.ca/parts/.
User avatar
rdub
Posts: 261
Joined: Wed May 23, 2007 7:18 pm
Member's Photo Album: http://www.delica.ca/Photos/
Location: aldergrove

Re: blanking plate

Post by rdub »

yes,and if the van is still warm ,it dosn't tic ,only when its cold.
I am stable in most situations that I have no reservations in stormy conditions.
Post Reply

Return to “L300 Technical”