fexlboi, do you know where i can get the aluminum hose fittings, bungs etc to weld onto the tank?
i will very soon be in the possession of a 5speed! my intention is to build a tank like yours, and another to install further up on the drivers side and connect with a hose like yours...
Additional tank - how?
Moderator: BCDelica
-
after oil
- Posts: 1436
- Joined: Mon Feb 11, 2008 7:01 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 92 cham-reimo poptop L300. 78MB240D
- Location: on the road
- Location: occupied coast salish territory aka powell river
-
fexlboi
- Posts: 1671
- Joined: Thu Jun 19, 2008 11:28 pm
- Member's Photo Album: http://dinoevo.de
- Vehicle: -
- Location: -
- Contact:
Re: Additional tank - how?
You can get everything at http://www.new-line.com or http://www.fairviewfittings.com in Burnaby (or some other locations)
The barb fittings I used are stainless steel. The aluminum bungs for the filler is a cut-off camlock the smaller bungs are regular from the store.
The barb fittings I used are stainless steel. The aluminum bungs for the filler is a cut-off camlock the smaller bungs are regular from the store.