Yokahama Geolander AT-S question

Mitsubishi Delica L400 production commenced in 1994 -- After much anticipation, the L400 arrived on Canadian Soil in 2009!
Post Reply
stonefly
Posts: 21
Joined: Tue May 04, 2010 6:57 am
Member's Photo Album: http://www.delica.ca/Photos/

Yokahama Geolander AT-S question

Post by stonefly »

Have L400 with stock 15" rims. I've read on the forum that some are running Geos at 265-70-r15. Just want to make sure that these will fit no worries of rubbing, etc. I know about the low pressure <potential> issue but never run low pressure. Other than that am I good to go? Have a set lined up in Red Deer here and just double checking.
TIA
Einstein
Posts: 54
Joined: Sun Nov 21, 2010 5:38 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: spacegear

Re: Yokahama Geolander AT-S question

Post by Einstein »

:-D i have them np rubbing that ive had.. but no extreme offroad done...
stonefly
Posts: 21
Joined: Tue May 04, 2010 6:57 am
Member's Photo Album: http://www.delica.ca/Photos/

Re: Yokahama Geolander AT-S question

Post by stonefly »

thx for the feedback. I assumed that was the case but you know how that goes. :)
Post Reply

Return to “L400 Technical”