Fluorescent Bulb

Looking for a specific hard-to-find Delica part? Post your request in this section. Commercial postings can be found in "Delica Trader Parts Section".

Moderators: delicanuck, mark

Post Reply
User avatar
Trapshooter
Posts: 49
Joined: Thu Jun 21, 2007 4:32 pm
Vehicle: 1991 Super Exceed
Location: Richmond BC

Fluorescent Bulb

Post by Trapshooter »

Hi. anyone know where can i get a interior Fluorescent Bulb for 91 L300 crystal high-roof ? Thanks.
User avatar
dfnder
Posts: 526
Joined: Wed Mar 05, 2008 9:36 pm
Member's Photo Album: http://www.delica.ca/Photos/
Vehicle: '91 Exceed
Location: Squamish

Re: Fluorescent Bulb

Post by dfnder »

Here is another thread that may give some more ideas...

http://www.delica.ca/forum/where-can-i- ... -4264.html
User avatar
nvanadm
Posts: 439
Joined: Sun Nov 09, 2008 10:48 am
Vehicle: 1993 L300 Super Exceed
Location: Canada

Post by nvanadm »

Sorry, I didn't ever follow up on that posting ^^^.

I just bought a bulb from home depot that was very close in size. It was a little fatter and just a little longer. I can't really remember the whole process, but I'm pretty sure I had to use tin snips to cut out a small piece of metal somewhere down the middle so I could just put it straight up. And because it was just a little bit longer I just bent the bi-pin holders out. It still works perfectly fine today. That was probably 3 years ago now.
User avatar
Trapshooter
Posts: 49
Joined: Thu Jun 21, 2007 4:32 pm
Vehicle: 1991 Super Exceed
Location: Richmond BC

Re:

Post by Trapshooter »

nvanadm wrote:Sorry, I didn't ever follow up on that posting ^^^.

I just bought a bulb from home depot that was very close in size. It was a little fatter and just a little longer. I can't really remember the whole process, but I'm pretty sure I had to use tin snips to cut out a small piece of metal somewhere down the middle so I could just put it straight up. And because it was just a little bit longer I just bent the bi-pin holders out. It still works perfectly fine today. That was probably 3 years ago now.
I went homedepot yesterday i found the one is T12 X 24" i think is what you use now . Will go get it to try . Thanks .
Post Reply

Return to “Parts Wanted (Non-Commercial)”