Inclinometer Ball for L400

[prairiefire]

I'm looking for a working or non-working Inclinometer ball for my L400. Mine has been painted over by the dumb@$$ I bought it from. Anyone know how to remove spray paint on plastic without damaging it? Acetone perhaps?

thanks,

K

[Pajero]

acetone may damage the plastic, but if its already useless then not much to lose my trying. I took mine out as i replaced it with a EGT gauge, So you could have mine but the greenish liquid has leaked out some where i think its supposed to be 1/2 full its only a 1/4 full

Joe

[claude]

acetone may damage the plastic, but if its already useless then not much to lose my trying. I took mine out as i replaced it with a EGT gauge, So you could have mine but the greenish liquid has leaked out some where i think its supposed to be 1/2 full its only a 1/4 full

Joe

Same problem , mine has no liquid in it. How hard it is to install a EGT gauge
Claude

[Pajero]

It was not too hard to do took a little time, but I bought the EGR blocking plate from here that had been drilled and tapped to fit the temp probe. If you do a search on here you can find more info on it. Its a good thing to have especially if you are going to tow anything.

Joe

[claude]

It was not too hard to do took a little time, but I bought the EGR blocking plate from here that had been drilled and tapped to fit the temp probe. If you do a search on here you can find more info on it. Its a good thing to have especially if you are going to tow anything.

Joe

I was wrong I took out the inclinometer and fund out it still had some liquid.
I shake few times and is working now

[prairiefire]

Still looking. Pajero's have bigger balls than the L400.

[tonydca]

PM sent