Page 1 of 1
Top Dead Center pls
Posted: Mon Feb 14, 2011 8:51 pm
by Super Exceeded
Ok, the head has been replaced. I had a look in this string, but can't seem to find any refernce on how to find top dead center to continue the process.
THX in advance.
Arnold
Re: Top Dead Center pls
Posted: Mon Feb 14, 2011 8:54 pm
by thedjjack
Should be mark on the crank pulley, watch the valves to see when both valves are closed on the cylinder you want top dead center on.
Waiting to hear it running!
Re: Top Dead Center pls
Posted: Mon Feb 14, 2011 9:00 pm
by Super Exceeded
THX assuming timing is based on the front cylinder!
Re: Top Dead Center pls
Posted: Mon Feb 14, 2011 10:49 pm
by jelbon
Turn it over with a wrench and make sure there is no binding. If you have the cam and rockers assembled and no cam belt fitted some valves will be opened and will collide with the pistons as they move.
Re: Top Dead Center pls
Posted: Mon Feb 14, 2011 10:51 pm
by thedjjack
I forgot the belt was off....that is funny since it was the start of the problem!
Top Dead Center pls
Posted: Tue Dec 26, 2017 2:07 pm
by Lapprentis
So can someone confirm that the TDC (Top Dead Center) position is confirm by the front of the engine marks on the Pulleys ? For Injection Pump Timing Purposes.
Thanks !
Lapprentis
Top Dead Center pls
Posted: Wed Dec 27, 2017 6:26 pm
by FalcoColumbarius
Lapprentis wrote:So can someone confirm that the TDC (Top Dead Center) position is confirm by the front of the engine marks on the Pulleys ? For Injection Pump Timing Purposes.
Thanks !
Lapprentis
Look in the engine manual, 11B: http://www.delica.ca/manuals/L-300%20Ma ... engine.pdf
Falco.