Re: skid plates

Post by **nxski** » Wed May 11, 2011 1:26 pm

I've posted a new thread about this because the other one was getting cluttered with comments. I'm making a one off for myself with my company logo on it and will be getting a quote on so
E basic ones similar to fishslappers but without the Mitsubishi/diamond design so as to cut down on cost. Butch at Cvi has expressed interest in ordering a few. I'm just looking for people who would be interested right now so I can give the company a number for a quote. When the quote is ready I'll post it on here so everyone has a chance to decide if they're still interested.

prairiefire · Post by **prairiefire** » Wed May 11, 2011 8:59 pm

Any thoughts on L400 plates?

Post by **nxski** » Wed May 11, 2011 9:00 pm

Here are the pictures of the designs I've sent in. The first is the one-off I'm making, the other two are the ones I'm getting priced to have multiples made.

PS. Please disregard the rectangular box in the third drawing, that is the restriction for the cutter.

Mine will be made from checker plate. I'm open for suggestions for the others...

Thanks

thedjjack · Post by **thedjjack** » Thu May 12, 2011 12:45 am

Careful with the logo...now if you run over someone the police will just have to look on the victims forehead to link it to you!

Post by **nxski** » Thu May 12, 2011 7:27 am

Haha, I guess Ill have to be very careful then

Post by **nxski** » Fri May 13, 2011 7:25 pm

Budget Pricing
material as 3/ 16 checker alum
hy def plasma (as we have prev cut )
raw alum pricing does fluctuate
pricing valid only up to My 31
I will be out of the office to May 25 and we could not take any orders until that time
there may have to be slight adjustments to logo spacing

1 piece as "NES" logo - $ 300.oo
1 - 5 pieces " no logo " - $ 250.oo each
1- 5 pieces " leaf type logo " - $ 300.oo each

lots of 12 per order
" no logo " - $ 200.oo each
" leaf type logo " - $ 240.oo each

lots of 24 per order
" no logo " - $ 140.oo each
" leaf type logo " - $ 180.oo each

This is the email quote I received. If anyone is interested let me know. This isn't meant to be a business opportunity, I won't mark anything up unless you would like them delivered. I'm making mine either way so if you're planning to do the same you could subsidize costs by doing it as a group. Like I said, Butch is in for 2 if the price is reasonable. I will talk to him again about it next week.

Nick

Post by **FalcoColumbarius** » Sat May 14, 2011 9:24 am

When you say the "Leaf type logo", are you referring to the "Mitsumaple"?

Falco.

Post by **nxski** » Sat May 14, 2011 2:13 pm

That was the wording of the guy who gave me the quote. Sorry, I missed the question about l400 skid plates. I did the design for this one myself but it will still need to be fit by them. If you want one done for your l400 shoot me a pm and ill give you the email of the guy to send your designs to.