Page 1 of 1

Can't find transmission pan torque spec...

Posted: Wed Oct 24, 2018 11:43 am
by sk66
Or at least not one I trust... this is all I can find in the manual, but the torques for the 10mm seem way high to me (50nm/35ftlbs).
Screen Shot 2018-10-24 at 10.13.34 AM.png
Screen Shot 2018-10-24 at 10.13.34 AM.png (18.3 KiB) Viewed 3853 times
Weird thing is, I suddenly developed a transmission seep/leak at the back of the pan... and when I checked the bolts they were all very loose, not much more than finger tight. Could a fluid change cause the gasket to soften? (I did not drop the pan)

Can't find transmission pan torque spec...

Posted: Wed Oct 24, 2018 12:27 pm
by deskinthewoods
I think those torques are for a 10mm diameter bolt, not a bolt that needs a 10mm socket...which would be a 5mm or 6mm bolt

Can't find transmission pan torque spec...

Posted: Wed Oct 24, 2018 12:47 pm
by sk66
That makes some sense, but doesn't help me much... :wink:

Can't find transmission pan torque spec...

Posted: Wed Oct 24, 2018 2:16 pm
by Growlerbearnz
"Engine and transmission tightening bolt" should be "engine *to* transmission bolts"- the ones on the bellhousing.

Oil pan is 4.5Nm/3.3ft.lb
torque.jpg
torque.jpg (159.19 KiB) Viewed 3836 times
(From the full workshop manual, which has a more comprehensive section on automatic transmissions. http://www.delica.ca/forum/viewtopic.php?f=17&t=17809)

Can't find transmission pan torque spec...

Posted: Thu Oct 25, 2018 7:55 am
by sk66
Growlerbearnz wrote:"Engine and transmission tightening bolt" should be "engine *to* transmission bolts"- the ones on the bellhousing.

Oil pan is 4.5Nm/3.3ft.lb

(From the full workshop manual, which has a more comprehensive section on automatic transmissions. http://www.delica.ca/forum/viewtopic.php?f=17&t=17809)
Thanks!
I went through every section of the manual where I thought it might be but I never found section 23A... still can't find it...