Injetor pressure?

loki · Post by **loki** » Sat Sep 20, 2008 12:42 pm

anyone know what pressure to use when pop testing the injectors?

loki · Post by **loki** » Sat Sep 20, 2008 1:01 pm

loki wrote:anyone know what pressure to use when pop testing the injectors?

found this on the uk site anyone agree or disagree?

14710 - 15690 Kpa OR
2133 - 2276 psi OR
150 - 160 Kg/cm2

fishslapper · Post by **fishslapper** » Sat Sep 20, 2008 9:23 pm

Does this mean that you are putting in your single tank wvo kit at last !!! ???? I hope so. I need to order my kit soon.....IT is always nice having people blaze trails for you !! lol's....

EricN · Post by **EricN** » Sun Sep 21, 2008 7:21 am

One of the manuals in the WIKI has the injector specs.

loki · Post by **loki** » Sun Sep 21, 2008 9:13 am

EricN wrote:One of the manuals in the WIKI has the injector specs.

I wasn't able to find the injector pressure in the wiki manuals, but that doesn't mean it isn't in there.

I have half a mind to order the russek manual, remove the binding and scan the whole thing with OCR and post it in the wiki.

loki · Post by **loki** » Sun Sep 21, 2008 9:16 am

fishslapper wrote:Does this mean that you are putting in your single tank wvo kit at last !!! ???? I hope so. I need to order my kit soon.....IT is always nice having people blaze trails for you !! lol's....

and yes it means the install is much closer now, once the injectors have been done and tested I can install the kit, we ran into problems again with the pump we ordered, after ordering it from a different company they too said that they can
t ship it to us out of the US anymore, going with a different company again, hope this one goes ok, if not I might go with a fuel pump out of a yacht.

Delica Canada | Mitsubishi Van Club

Injetor pressure?

Injetor pressure?

Re: Injetor pressure?

Re: Injetor pressure?

Re: Injetor pressure?

Re: Injetor pressure?

Re: Injetor pressure?