Shaft to transfer case

Does your Mitsubishi L300 make a strange noise? Need wheel alignment specs?
Post Reply
User avatar
rdub
Posts: 261
Joined: Wed May 23, 2007 7:18 pm
Member's Photo Album: http://www.delica.ca/Photos/
Location: aldergrove

Shaft to transfer case

Post by rdub »

I went to pull the drive shaft to the transfer case today to take it in to get new joints put in,ive done this before but ive never had gear oil come out like it did when pulling it from its sleeve? when i did it before on my old truck it was splined,not the case this time,i was hopping to pull it and take it in so i could still drive around.My question is will i need to dump the gear iol ,or can i get some kind of a cap to stop the flow for the time being. 5 speed manual.

Thanks
Rich. :M
I am stable in most situations that I have no reservations in stormy conditions.
Top
Post Reply

Return to “L300 Technical”