I don't think this is a good thing!

Confusedone · Post by **Confusedone** » Sat Jun 10, 2017 6:19 pm

: 1-IMG_20170610_165905391.jpg (26.66 KiB) Viewed 3524 times

204explorer · Post by **204explorer** » Sat Jun 10, 2017 6:20 pm

Broken timing belt?

Sent from my SM-G920W8 using Tapatalk

Post by **Growlerbearnz** » Sat Jun 10, 2017 10:11 pm

You're right, that's quite a bad thing.

The only silver lining is that the rockers are designed to break when the piston hits a valve, rather than bending the valve. You'll still have to remove the head and check all the valves for straightness, the head for cracks, and the cam and its bearings for alignment, but you might get away with just replacing those rockers and the rocker shaft. Obviously check the remaining rockers for cracks too.

Watch for stripped bolt holes on the cam caps and rocker shaft bolts. They can be heli-coiled to repair them.

Confusedone · Post by **Confusedone** » Sun Jun 11, 2017 9:16 am

THank you Growlerbearnz.
Good to know i may not have to replace the whole head!