Clunking in the rear on L400's going over bumps is normally excess play in the rear sway bar links and rear sway bar bushes.Just grab the rear sway bar and see if there is any movement up and down on both sides.
Hope this helps to put an end to you going crazy!!!!
Is there another L400 in Calgary?
-
- Posts: 126
- Joined: Sun Jun 07, 2009 2:47 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1991 Mitsubishi Pajero
- Location: Vancouver Island B.C
- Contact:
-
- Posts: 92
- Joined: Sat Feb 21, 2009 9:59 am
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: L400 Super Exceed
Re: Is there another L400 in Calgary?
Hope not. The Clunk started to happen post Pro Active... Maybe, I'll get up on a hoist and take a look.
-
- Posts: 460
- Joined: Mon Nov 10, 2008 2:03 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1994 l400
- Location: calgary Alberta
Re: Is there another L400 in Calgary?
well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick
- Erebus
- Posts: 1369
- Joined: Mon May 28, 2007 7:55 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1992 Super Exceed
- Location: Edmonton, Alberta
- Location: Edmonton (was Calgary until 2017), Alberta, Canada
- Contact:
Re: Is there another L400 in Calgary?
In-line heaters suck compared to block heaters. Don't bother with an in-line, waste of money. Block heater is the way to go.madmazda wrote:well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick

-
- Posts: 3257
- Joined: Wed Jul 19, 2006 9:18 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 1994 L400 Royal Exceed PF8W
- Location: Calgary Alberta Canada
- Contact:
Re: Is there another L400 in Calgary?
talk to mardy, he's now done a block heater on my new L400, so I'm sure he can give you pointers on how to install one...
- DelicaFreaka
- Posts: 113
- Joined: Sat Oct 03, 2009 9:03 pm
- Member's Photo Album: http://www.delica.ca/Photos/
- Vehicle: 94 L400 4M40
- Location: Okanagan B.C.
Re: Is there another L400 in Calgary?
Here, check this out. It is a fairly simple install if you know your way around some simple tools. I will be doing mine shortly. Just remember that after you drain the rad and pull the line off the rear heater unit you will still have some coolant gush from the right rear frost plug when you bang it out. Put a tarp down to catch or stuff some towels under the plug to soak most of it up as it comes out. A little tight to get at but definitely can be done. No lifting of the vehicle required. Good luck...........................Kirk out.madmazda wrote:well i live in calgary and am going to be a new owner of a delica spacegear really soon...... I'm hoping I can find a block heater.... hopefully an in line one will do the trick
****Block Heater Part # (found at Lordco) 3100049..... $35.00 ****
http://www.delica.ca/forum/block-heater ... -6592.html
********** Starship Delica **********
"To boldly go where no man has gone before"

"To boldly go where no man has gone before"
