Delica Canada | Mitsubishi Van Club

Also check the overdrive temp sender , If disconnected the OD is locked out . The thought for it is the Deli will not shift to while cold , once warmed up it shifts . Silly idea , bypass the sender by attaching the sender wire to ground and leave it like that , it rules out the sender, Other possibi...

I put in a $400 aftermarket one from Rocky Mountain , works perfectly.

Check this recent post , l400 in accident being parted out
http://www.delica.ca/forum/viewtopic.php?f=1&t=16448

If I'm not mistaken there is a mechanical high idle mechanism on l 400s for warm up, look it up in the manual , never adjusted mine

Get you parts threw Rocky Mountain imports http://www.rockymountainimports.net/
Had mine done at a shop. .

I drive the same thing , glad your ok sorry about your Deli. I'll take the A/C compressor if your parting it out .

I went the same route of seeking a reputable dealer and ended up getting a great one from Mardy years ago. Would I go that way again, no. I would look for a private deal from a forum member that has had a few years to get the bugs out , no matter what dealer you get it from things will show up , Rub...

That's what I needed to know , thanks Mat .

It's time to do my front sway bar end links . Does anyone know if these are under load while the van is sitting. Or do you have to lift the van to take pressure off of the sway bar ? If not it looks simple enough . Thanks in advance for any advice.

Mine is a SWB low roof for the same parking reason , Just last week I got into a hotel in Vancouver with 6' 5" clearance . Many have seats that fold into a full or half bed . I find with an thermarest on top to cover the lumps it's pretty comfortable and you still have the seats when you need t...

Could use an A/C compressor and TPS unit.

Alternator , all kinds of weird electrical issues come up when deli alternators are dying .

Check the rubber insert on the front of the engine under the valve cover . It's part of the gasket system and is prone to spontaneous leaks. About 35$ for a new gasket kit. The pulleys are available aftermarket on eBay for around 70$ , be aware the newer pulley style requires a different front seal.

I'm looking for one too. Or a broken one with good bearings

Check your overdrive temp sensor first , you can short the wire to ground then see if it will shift to od , yes the speed sensor and tps are also involved , you can easily check the tps for adjustment vita a volt meter.